Team kalorik TKG SM 1003 Manual De Instrucciones página 6

Fax +32 2 359 95 50
USE
•
Protective coating burn off will cause smoking on first use. This is NOT harmful and will
disappear after a short time.
•
When using for the first time, wipe the surface of the plates with a damp cloth, then dry. You
may season the plates with butter, margarine or cooking fat. Since the sandwich maker has
a non-stick surface, the use of butter or oil is optional.
•
Close the sandwich maker and plug into the electrical outlet. The red pilot light will come
on to indicate that the appliance is switched on.
•
Prepare your sandwich while the unit is heating.
•
The green pilot light will come on as well when the cooking temperature is reached.
During use, this ready light will come on and off regularly. This simply means that the
thermostat is regulating the appliance's temperature.
•
Fully open the sandwich maker. Place a slice of bread in the bottom half with the
buttered side against the plate.
•
Fill the sandwich.
•
Add the top slice with the buttered side up and carefully close the toaster. Do not force
shut. Steam will be ejected from between the plates; make sure that fingers do not come
into contact with the steam.
•
Lock the two halves with the wire clip while toasting.
•
Your sandwich will be toasted in 2 to 3 min or longer to suit your taste. Open the toaster
and remove the sandwich using a plastic or wooden spatula. Never use a metal knife as
this may damage the non-stick coating.
•
Close the lid to preserve the heat until you are ready to toast the next sandwiches.
•
Prepare additional sandwiches if desired while the others are cooking.
•
Unplug when finished.
HINTS FOR BEST RESULTS
•
Always preheat before use. Plug cord into power outlet while preparing the fillings.
•
Flavoured butter may also be used.
•
For additional flavour use bacon dripping. Brush drippings on the outside of the bread.
CLEANING
•
Before cleaning, unplug and wait for the appliance to cool down.
•
Wipe the outside with only a slightly moistened cloth ensuring that no moisture, oil or
grease enters the cooling slots.
•
Wipe the inside and the edges of the plate with a paper towel or a soft cloth.
•
Do not clean the inside or outside with any abrasive scouring pad or steel wool as this will
damage the finish.
•
Do not immerse in water or any other liquid.
PROTECTION OF THE ENVIRONMENT – DIRECTIVE 2002/96/EC
In order to preserve our environment and protect human health, the waste electrical and
electronic equipment should be disposed of in accordance with specific rules with the
implication of both suppliers and users. For this reason, as indicated by the symbol
rating label or on the packaging, your appliance should not be disposed of as unsorted
municipal waste. The user has the right to bring it to a municipal collection point performing
waste recovery by means of reuse, recycling or use for other applications in accordance with
the directive.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
6
Assembly page 6/28
on the
TKG SM 1003 - 100310