What If There Are Problems; Disposal; Technical Specifications - Beurer LB 88 Instrucciones De Uso

10. What if there are problems?

Problem
The operating loop
does not light up.
No LED display.
Red LED display.
No mist is produced. The LED display lights up red.
The mist has a
strange smell.
Strange noise.
Mist escapes from
underneath the
water tank.

11. Disposal

For environmental reasons, do not dispose of the device in the household waste at the end of its
useful life. Dispose of the unit at a suitable local collection or recycling point. Dispose of the device
in accordance with EC Directive – WEEE (Waste Electrical and Electronic Equipment). If you have
any questions, please contact the local authorities responsible for waste disposal.

12. Technical specifications

Dimensions (L x W x H)
Cable length
Weight when empty
Mains voltage/frequency
Nominal power
Cause
The mains cable is not plugged in. Connect the plug.
The control dial is at its minimum
position.
The mains cable is not plugged in. Connect the plug.
The control dial is at its minimum
position.
The water level is too low; the water
tank is empty.
The LED display does not light up. Connect the plug.
The device is new.
Stale or dirty water.
The water tank is not positioned
correctly on the base unit.
There is too little water in the water
tank.
The device is not level and unstable. Place the device on a firm, level surface.
The water tank is not positioned
correctly on the base unit.
Approx. 29.5 cm x 19.5 cm x 28 cm
Approx. 1.4 m
Approx. 2.24 kg
220-240 V AC / 50/60 Hz
280 W
Solution
Turn the control dial clockwise towards the ma-
ximum position.
Turn the control dial clockwise towards the ma-
ximum position.
Fill the water tank.
Fill the water tank.
Remove the water tank, turn the screwed plug
and remove it.
Air the open, empty water tank in a cool, dry
place for twelve hours.
Empty the base unit and the water tank and
clean them thoroughly.
Fill the water tank with fresh water.
Lift up the water tank and position it correctly
on the base unit.
The tank should sit tightly on the base unit.
Fill the water tank.
Lift up the water tank.
Check whether the join between the base unit
and water tank is clean.
Clean if required.
Position the water tank correctly on the base
unit.
The tank should sit tightly on the base unit.
23