NSK Prophy-Mate neo Serie Manual De Instrucciones página 7

4-3 Cleaning and washing
1) Carefully clean the inside of the joint section of the
handpiece and the O-ring section of the powder
case with the attached cleaning brush. (Fig. 11)
If powder adheres to the O-ring section, remove
the O-rings, and carefully clean the O-rings and
grooves. (Fig. 12)
2) Remove the rubber packing and disassemble the
powder case cap. (Fig. 13)
3) Wash away the cleaning powder adhering to the inside of the
powder case/powder case cap under running water. (Fig. 14)
4) Dry and assemble the powder case cover, rubber gasket and
cover holder.
CAUTION
If cleaning powder remains in the powder case, powder will
cake up, and this may cause clogging.
Rubber packing
10
4-4 Lubrication
1) Dry the O-ring section of the powder case, apply a
drop of the enclosed turbine oil and rub it in with
your finger. (Fig. 15)
2) Perform autoclave sterilization.
Fig.11
CAUTION
If lubrication of the O-rings is neglected the joint between the powder case and handpiece may be
damaged. Powder case and handpiece may no longer swivel freely and the joint may leak.
Fig.12
Fig. 13
Fig.14
OIL
11
Fig.15