Onkyo CS-265 Manual De Instrucciones página 36

Troubleshooting—Continued
Tuner
Reception is noisy, stereo FM reception suffers from hiss, the Auto Preset function doesn't preset
all stations, or the FM ST indicator doesn't light up when tuned to a stereo FM station.
• Check the antenna connections (see page 14).
• Change the position of the antenna (see page 14).
• Move the CD receiver away from a nearby TV or computer.
• Cars or airplanes can cause noisy interference.
• The radio signal will be weakened if it has to pass through a concrete wall before reaching the antenna.
• Switch to Mono mode and listen in mono. The FM ST indicator will go off (see page 26).
• If none of the above improves the reception, install an outdoor antenna (see page 14).
Can't adjust the frequency of the radio.
• Use the remote controller's [eTUNING]/[TUNINGr] buttons to change the frequency of the radio (see page 26).
RDS information doesn't appear.
• The FM station you are tuned to doesn't support RDS.
• The radio signal is weak. Change the position of the antenna. If the situation does not improve, install an outdoor
FM antenna (see page 14).
External Components
No sound is heard from your turntable.
• Make sure the turntable has a built-in phono equalizer. If the turntable doesn't have a phono equalizer built-in,
you must provide one.
Timer
The timer doesn't work.
• Make sure the clock has been set correctly (see page 29).
• Timed operation will fail if the CD receiver is on at the specified On time, so make sure it's set to Standby (see
page 30).
• If a power failure occurs and the clock stops, the timer will be disabled. Reset the clock, and then enable Timer
as you desire.
Clock
The display indicates "- - : - -" when you press the [CLOCK CALL] button.
• A power failure has occurred, and the clock has stopped. Set the clock again (see page 29).
Others
Standby power consumption.
• Charging will begin when you connect an iPod/iPhone/iPad, causing the power consumption to increase.
Charging will occur even if the CD receiver enters standby mode.
Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit's
malfunction. Before you record important data, make sure that the material will be recorded correctly.
The CD receiver contains a microcomputer. In very rare situations, severe interference, noise from an external
source, or static electricity may cause it to malfunction or lock up. In the unlikely event that this should happen,
unplug the power cord, wait at least 5 minutes, and then plug it back in again. If this doesn't resolve the issue,
reset the CD receiver to its factory defaults (see page 31).
34
En-