Technical Specifications; Replacement Parts And Wearing Parts; Warranty/Service - Beurer EM 32 Instrucciones Para El Uso

― Ensure that no water penetrates into the device. If this should ever happen then only use the device
once it is completely dry.
― Do not use any chemical cleaners or abrasive agents for cleaning.
― Once you have removed the device (operating unit), you can wash the belt in luke warm water. Use mild
soapy water or a liquid detergent for this purpose. Do not use bleaches.
― The belt is unsuitable for machine washing.

8. Technical Specifications

Model:
Power supply:
Electrode size:
Parameter (500 Ohm load):
Pulse duration:
Waveform:
Weight:
Belt size for waist measurement from
Maximum permissible operating conditions:
Maximum permissible storage conditions:
Changes to the technical specifications introduced for reasons of updating without notice are reserved.

9. Replacement parts and wearing parts

Replacement parts and wearing parts are available from the corresponding listed service address under
the stated material number.
Designation
Accessory set

10. Warranty/service

In case of a claim under the warranty please contact your local dealer or the local representation which is
mentioned in the list "service international".
In case of returning the unit please add a copy of your receipt and a short report of the defect.
The following warranty terms shall apply:
1. The warranty period for BEURER products is either 3 years or- if longer- the country specific warranty
period from date of Purchase.
In case of a warranty claim, the date of purchase has to be proven by means of the sales receipt or
invoice.
2. Repairs (complete unit or parts of the unit) do not extend the warranty period.
3. The warranty shall not be valid for damages because of
a. improper treatment, e.g. nonobservance of the user instructions.
b. repairs or tampering by the customer or unauthorised third parties.
c. transport from the manufacturer to the consumer or during transport to the service centre.
d. The warranty shall not be valid for accessories which are subject to normal wear and tear (cuff,
batteries etc.).
4. Liability for direct or indirect consequential losses caused by the unit are excluded even if the dama-
ge to the unit is accepted as a warranty claim.
EM 32
3 x 1.5 V AAA (type LR 03)
approx. 11 x 10 cm
– Output voltage max. 70V p-p
– Output current: max. 140mA p-p
– Output frequency: 30 – 80Hz
200µs per phase
symmetrical, dual-phase square wave
~ 240 g (without batteries)
70 to approx. 140 cm. (28 – 55 Inch)
10 °C to +40 °C, 20-65% relative humidity
0 °C to +55 °C, 10-90% relative humidity
Item number and/or order number
647.05
16