Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2
Decorative light
switch
3
Power LED
4
Charging indicator
5
Signal transmitting
6、 7 Recharging
positive & negative
electrode
8
Charging power DC
socket
Some essence may damage the plastic surface, so please make purchase
and use after consideration.
Space isolator
Space isolator display and control panel :
Overall display
Function Introduction of Space Isolator :
Space Isolator, an accessory of the cleaner, can block area by sending special infrared
signal so as to prevent the Cleaner from entering some unnecessary areas.
Using Method & Functional Status of Space Isolator :
No.
Name
1
Toggle switch
a
Turn off
b
Low
c
Middle
2
d
High
3
Infrared wall transmitting signal head
4
Near-infrared transmitting
head
Power LED
Press the switch to turn on/off while the decorative light is on.
The power LED will light when the docking station is connected with the power, or
turn off if not connected.
The indicator will flicker while the recharger is connected with the cleaner.
Transmitting signal is the only way to lead the cleaner to return the docking
station for charging, so the signal transmitting position should be clean for long
without any obstacle on it.
The electrode and that of the cleaner are connected to charge under contact
mode, so the position should be clean without any obstacle on it while using, or
there will be impact to the charging.
The power DC socket, called recharger for short, used to connect output terminal
DC24V of the adaptor, is the charging transit station between the cleaner and
adaptor, so the recharger should be placed against the wall firmly and the adaptor
cable should be away from the recharger, or the robot may have impact and
winding during cleaning.
You can switch the function by sliding
Middle and High.
Slide
Slide
within 4m as required by infrared wall.
Slide
distance within 6m as required by infrared wall.
Slide
within 8m as required by infrared wall.
Slide
The near-infrared transmitting signal makes the Cleaner
run outside the Space Isolator scope of 50-100cm without
any impact to it.
The Power LED will flicker once every 8s until the low
battery after you
and
High, and the Cleaner works normally.
Function instructions
1. Toggle switch
Function information
to the position, then the power is off.
to Low and turn on the power, you can select the distance
to Middle and turn on the power, you can select the
to High and turn on the power, you can select the distance
, then you can adjust the distance of the Space Isolator.
slide
to Low,
a
Turn off
b
Low
c
Middle
d
High
repeatedly : Turn off, Low,
Middle
Capítulos
Tabla de contenido
