Work Clamp; Dust Bag - Delta 26-2240 Manual De Instrucciones

• Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alteration or
modification is misuse and could result in a hazardous condition.
• Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting.
• Do not start the miter saw without checking for interference between the blade and the miter fence. Damage could result to the
blade if it strikes the miter fence during operation of the saw.
• The saw can tip over if the saw head is released suddenly and the saw is not secured to a work surface. ALWAYS secure this saw
to a stable work surface before any use.
• If any parts are damaged or missing do not operate this tool until the parts are replaced. Please call Customer Care Center at
800-223-7278, for instructions.

WORK CLAMP

The vertical work clamp secures the workpiece to the table to
provide more stability and keeps the workpiece from creeping
toward the saw blade.
To install the vertical work clamp, see Figure 8 and do the
following:
1.
Place the clamp shaft (A) in either hole (B) on the miter
base.
2.
Rotate the knob (C) on the clamp clockwise to move it
in or counter clockwise to move it out as needed.

DUST BAG

The Tool includes a dust collection bag (D) that attaches over
the exhaust port on the upper blade guard. Slide the plastic
collar onto the dust exhaust port on the back of the saw head.
See Figure 9
NOTE:
To remove the dust bag for emptying, simply reverse
the above procedure.
ASSEMBLY
11
A
B
Figure 8
D
Figure 9
C