Urmet 1093/181WM1 Guía Rápida página 14

4.2 MODE ACCESS POINT WIFI CONFIGURATION
This mode is used to configure the wireless network interface of the camera without wiring it to
the network. It is an alternative to section 3.1.
The camera is automatically set to Access Point mode if it was never configured in a WiFi
network. A PC
In this case, network configuration may be performed after having fitted and powered the camera
in its final position.
The following steps must be performed for configuration:
1. Search from the available WiFi networks on the PC. The camera has a
"URM_MacAddress" SSID. Select this SSID to connect the PC to the camera.
2. Run steps from 1 to 6 described above in section 3.1.
3. When the camera connects to the configured WiFi, it stops working in Access Point
mode and disconnects from the PC. For this reason, the PC must be connected to
the LAN before pressing the "Refresh List" button of the "EasyTool" program and
detect the camera again in the network.
Run steps from 8 to 9 described above in section 3.1.
4.
4.3 STATIC IP ADDRESS ALLOCATION
The network parameters of the camera, such as IP address, subnet mask and gateway may be
set and modified using "EasyTool" provided or on the camera web page.
It is advisable to set a static IP address after having appropriately connected and configured the
camera in the network (see previous sections). Make sure that the IP address you want to assign
to the camera is not already used in the network. It is better to use an address outside the range
of addresses assigned by means of DHCP.
To assign the static IP address, select the camera after having detected it in "EasyTool". As
shown in the figure below, fill in the static network parameter to be assigned (the fields are filled
in automatically by selecting the correct network interface from those available on the PC) in the
specific section of the tool.
Press "Modify IP Address" (Modifica indirizzo IP) to change the IP address of the device and wait
for a few instants.
14
with wireless network board is needed to configure it.
DS1093-558