ECOFOREST CANTINA NOVA Manual De Instalación Y Mantenimiento página 48

It is recommendable to calculate the frequency with which you clean the outlet cleaning considering the
hours of operation, thus avoiding ash saturation.
Once you clean the walls of the stove, you must be sure that the cleaning outlet is securely closed, since the
proper operation of the stove depends on this cleaning.
5.6. Cleaning of the gas outlet circuit. Always with the boiler disconnected. (Very important).
For an optimal cleaning of the extractor's collector, it is recommended to dismantle the extractor itself in
order to have full access to this zone for a better cleaning. To do this, remove the screws that secure the
edges of the rear grille and remove the boiler, o or pull out the boiler from its embedded space if it is a Super
Insert model, thus getting full access to the extractor. Once the extractor is dismantled, clean it with a dry
brush and be careful with the turbine and structure.
When reassembling the exhaust it is COMPULSORY to replace the exhaust joint with a new one as you run
the risk of gas entering in our home.
Exhaust circuit extractor.

Ceramic fiber joint (replace).

5.7. Dismantling and cleaning of gas outlet pipes.
When mounting the gas outlet pipeline, make sure it is well assembled, preferably sealed with silicone. If the
pipe has sealing joints, you must verify its good condition and replace it if necessary.
5.8. Lubrication of the screw and spring of the gas security valve. It is located to the left of the ash box. To access
and lubricate the anti-explosion valve, open the boiler doors, remove the ash box and push the round plate
outwards, thus allowing lubrication of the valve screw and spring.
Lubrication point.

5.9.
Empty the hopper to take remaining pellets out to avoid pellets absorb humidity.
5.10. Review the fireplace door joints.
Review in detail any imperfections which may cause an air inlet. Replace them if necessary.
47
Drawing 23
Drawing 24