Tabla de contenido
Idiomas disponibles
Idiomas disponibles
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like
short-circuit, burns, electric shock, lamp explosion, crash etc.
RIGGING
The device can be installed on the ground or on the wall or ceiling.
Standing Installation
Install the device in a well-ventilated area.
Only install the controller on scratch resistant surfaces.
Hanging Installation
Before attaching the device, make sure that the installation area can hold a minimum point load of 10 times
the device's weight.
The device must only be installed absolutely planar at a vibration-free, oscilation-free and fire-resistant
location. Make sure that the device is installed absolutely planar by using a water-level.
The device must be installed out of the reach of people.
The device must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
Procedure:
Step 1: On the baseplate, there are the holes for the installation.
Step 2: Hold the baseplate onto the location where the device is to be installed.
Step 3: Mark the boreholes with a pen or a suitable tool.
Step 4: Drill the holes and screw the appropriate screws into the installation surface until almost plane.
Step 5: Hold the baseplate in the desired position and hang it onto the screws.
Before taking into operation for the first time, the installation has to be approved by an expert!
OPERATION
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
Connect the connection-cable ends with the sockets of the LED luminaries and the controller.
For the optimal program flow, please connect the number of Cubes/Panels as follows: minimum 4, 6, 8, 10,
12, 14, or maximum 16.
DANGER TO LIFE!
DANGER OF FIRE!
13/27
51930480_V_1_1.DOC
Tabla de contenido
