Garland XTRIM 140 DW Manual De Instrucciones página 33

designed. Any other use can be dangerous for the
user, for the machine and for people, animals and
things that may be around.
Check:
- The machine completely and look for loose parts
(bolts, nuts, etc.) and damage.
- That the protector is correctly fixed to the machine.
- That the head is not damaged.
Tighten, repair or replace anything necessary before
using the machine.
5.3.2. TURN ON AND TURN OFF
On / off button
Throttle trigger
Turning on the machine:
Install battery
Press the on / off button, (if everything is correct the
green light will stay fixed, if there is a problem the
green light will blink) then press the safety button and,
without releasing it, press the accelerator trigger.
Disconnecting the machine:
Release the throttle trigger, press the on / off button,
if you are not going to use it for a long time remove
the battery.
After turning off the machine, the cutting tool will
continue to rotate for a few moments due to inertia.
Wait until the cutting tool stops before servicing or
transporting the machine.
Security button
33/124
5.3.3. VERIFICATION POINTS AFTER START-UP
It is important to pay attention to possible loose parts
or and the temperature of the machine. If you detect
any anomaly in the machine, stop immediately and
check it carefully.
In the event of any anomaly or problem, take the
machine to the technical service for repair. In no case
continue using the machine if the operation does not
seem adequate.
Do not use the machine if it is damaged or
incorrectly set.
5.4. BATTERY CHARGE
The supply voltage and current must comply with
the indications on the charger's nameplate.
Before using the battery for the first time, charge it for
at least 1 hour for the 4 Ah and 40 min for the 2 Ah
To charge the battery, plug the charger into the
mains, the led will light up red. Place the battery in
the charger, the led will turn green and start flashing.
The charger LED will turn from flashing green to green
when the battery is fully charged. When the battery is
charged, remove it from the charger. If you leave the
battery in the charger and it is charged, the charger
will automatically turn off after 2 hours, continuing the
green LED on.
If you insert the battery into the charger and the led
starts to flash red, it means that your battery is bad or
that the battery does not correspond to this charger.
Important! If you fully charge your battery,
disconnect it from the charger and reconnect it
without having used it, the led may start to blink red
(bad battery sign) when it detects that the battery does
not accept a charge. In this case the flashing red of
English