Impeller Replacement - CountyLine CL108 Manual Del Usuario

Maintenance

Impeller Replacement:

For impeller replacement refer to Figure 2.
Cover
Plate
Cover Screws
Figure 2 - Impeller replacement.
1. Loosen and remove the cover screws.
2. Remove the cover plate and the O-Ring.
3. Remove the outer wear plate.
4. Remove the old impeller and cam ring and
discard them.
5. Examine the inner wear plate for wear. If it is
worn, remove it, turn it over and reinstall it.
6. Grease the outside diameter of the new cam
ring with silicone grease and install it.
7. Put a small amount of the same grease on the
inside diameter of the cam ring and on the
surface of the wearplate.
8. Install the new impeller. Be sure to align the
flat on the impeller with the flat on the motor
shaft. See Figure 3.
Align the impeller
flat with the flat
on the shaft.
Figure - 3 Be sure to align the flat on the
impeller with the flat on the shaft.
Cam
Ring
Impeller
Outer
Wear
Plate
(Turn over inner
O-Ring
wear plate if scored)
3786 1000
9. While installing the impeller, twist it in a
clockwise direction (impeller blades will be
bent). See Figure 4.
Twist the Impeller
in a clockwise
direction when
installing
it on the shaft.
Inner
Wear
Plate
3785 1000
Figure - 4 Turn the impeller clockwise during
installation.
10. Reinstall the outer wearplate and O-Ring.
11. Reinstall the cover plate.
12. Reinstall the screws. Tighten the screws
moderately first and then snug them down.
To replace the Fuse (Refer to Figure 5):
1.
Gently pull the fuse
holder apart.
Fuse Holder
Figure 5 - Fuse replacement.
1. Gently pull the fuse holder apart and remove
the old fuse (See Step 1).
2. Push the new fuse firmly up into the fuse
holder (See Step 2).
3. Reassemble the fuse holder (See Step 3).
2.
3.
Replace the old fuse
with the new fuse.
New
Fuse
5
3787 1000
Reassemble the
fuse holder.
Old
Fuse
3788 1000