Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Safety
Important Safety
Instructions
SAVE THESE INSTRUCTIONS - This manual
contains important instructions that should be
followed during installation, operation, and
maintenance of the product.
This is the safety alert symbol. When you
see this symbol on your pump or in this manual,
look for one of the following signal words and
be alert to the potential for personal injury!
indicates a hazard which, if not
avoided, will result in death or serious injury.
indicates a hazard which, if not
avoided, could result in death or serious injury.
indicates a hazard which, if not
avoided, could result in minor or moderate injury.
NOTICE addresses practices not related to
personal injury.
Carefully read and follow all safety instructions
in this manual and on pump .
Keep safety labels in good condition. Replace
missing or damaged safety labels.
California Proposition 65 Warning
This product and related
accessories contain chemicals known to the
State of California to cause cancer, birth defects
or other reproductive harm.
Risk of fire and explosion . Can
cause severe injury, property damage or death.
Do not use in explosive atmospheres. Do not
pump flammable liquids.
Specifications
Liquid Temp. Range .............. 35° to 120° F (1.7° to 50° C)
NOTICE Never operate the pump for more than
two hours at a time. Never run the pump dry!
NOTICE This unit is not designed for
applications involving salt water or brine! Use
with salt water or brine will void warranty.
Performance
Total Feet (m)
0 (0)
10 (3)
Capacity Gallons (L) / Hour
450
390
(1,703)
(1,476)
DC Motors
1. DC motors must be connected to a fully
charged automotive, tractor or marine type
battery of the proper voltage.
2. Life expectancy of the motor is 500 to
1000 hours.
20 (6.1)
30 (9.1)
40 (12.2)
300
225
(1,136)
(852)
For more information, see your retailer, or call
customer service
1. This equipment is only for use with an
automotive, tractor or marine type battery fully
charged to 12 Volts DC.
can cause severe burns and start a fire if the
battery is short circuited.
2. Know the pump application, limitations, and
potential hazards.
3. Do not use this pump in water with
fish present.
4. Release all pressure within the system before
servicing any component.
5. Drain all water from the system
beforeservicing.
6. Secure the discharge line before starting
the pump. An unsecured discharge line can
whip, possibly causing personal injury and/or
property damage.
7. Check hoses for weak or worn condition
before each use, making certain all
connections are secure.
8. Periodically inspect the pump and system
components. Keep free of debris and foreign
objects. Perform routine maintenance as
required. See Maintenance.
9. Provide a means of pressure relief for
pumps whose discharge line can be shut-off
or obstructed.
10. Personal Safety:
a. Wear safety glasses at all times when
working with the pumps.
b. Keep work area clean, uncluttered and
properly lighted.
c. Keep visitors at a safe distance from the
work area.
d. Make the workshop child-proof – with
padlocks, master switches, and by
removing starter keys.
11. When wiring a DC pump, follow all of the
electrical and safety codes that apply.
12. All wiring is to be 12 gauge stranded copper
wire that is:
A. Water resistant
B. Oil resistant
C. Flame resistant
130
NOTICE This pump is equipped with a
(492)
permanent magnet type 12 Volt reversible
DC motor. Be sure it is connected properly as
illustrated for the direction of flow indicated by
the arrows on the pump case (see Figure 1).
13. Use insulated crimp type connectors.
Risk of burns . Battery current
2
Tabla de contenido
