Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6. Wiring.
CAUTION: Be sure outlet box is properly grounded
and that a ground wire (GREEN or Bare) is
present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to in the instructions
below, please use a qualified electrician.
Note: Excess lead wire length from the fan can be
cut to the desired length and then stripped.
When downrod is secured in place on the
hanging bracket, electrical wiring can be made
as follows:
Connect BLACK wire from fan to BLACK wire
from ceiling with wire connector provided.
Connect WHITE wire from fan to WHITE wire
from ceiling with wire connector provided.
Connect all GROUND (GREEN) wires together
from fan to BARE/GREEN wire from ceiling with
wire connector provided.
Since this fan does not come with a light kit,
you will need to cap off the BLUE wire with a
wire connector (as shown with arrow in
diagram).
[Note: If you elect to purchase a light kit for the
fan, the BLUE wire from the fan must be
connected to the BLACK wire from the ceiling
instead.]
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
This fan is remote control adaptable (remote
control sold separately).
7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded part
of slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy to
lock. Re-insert screw that was removed and then
tighten both screws securely.
white supply wire
black supply wire
from ceiling
black
white
white
black
blue
from fan
canopy
screw
page 6
ground
(green or bare)
wire
connector
ground
(green
or bare)
*
hanging bracket
screw
Capítulos
Tabla de contenido
