Accessories; In-Car Connections - Philips EXP 301 Manual De Instrucciones

In-car connections

Only use the AY 3545 car voltage converter (4.5 V DC, positive pole to the
center pin) and the AY 3501 car adapter cassette. Any other product may
damage the unit.
1
Put the unit on a horizontal, vibration-free and
stable surface. Make sure it is in a safe place,
where the unit is neither a danger nor an
obstacle to the driver and the passengers.
2
Connect the DC plug of the voltage converter
to 4.5V DC on the unit (only for a 12 V car
battery, negative grounding).
3
Insert the voltage converter into the cigarette
lighter jack. If necessary, clean the cigarette
lighter jack to obtain a good electrical contact.
4
Turn down the volume and connect the adapter cassette plug to
LINE OUT/p on the unit.
5
Carefully insert the adapter cassette into the car radio's cassette compartment.
6
Make sure the cord does not hinder your driving.
Set VOL E on the unit to position 8. Start playback on the unit and adjust
7
the sound with the car radio controls.
Always remove the voltage converter from the cigarette lighter jack
when the unit is not in use.
Note: If your car radio has a LINE IN jack, it is better to use it for the
car radio connection instead of the adapter cassette. Connect the signal lead to
this LINE IN jack and to LINE OUT/p on the unit.
(supplied or optionally available)

Accessories

4.5 V DC
O
F F
• R
E S
U
M
E •
H O
L D
L IN
E O
U T
/
OP EN
L .
V O
25