Reverse Door Swing (Optional) - Kenmore W10850306A Instrucciones De Instalación

REVERSE DOOR SWING (OPTIONAL)

NOTE: Magnetized screwdriver is helpful.
1.
Place towel on dryer
Place towel on top of dryer to avoid damaging the surface.
2.
Remove bottom screws
Open dryer door. Remove bottom screws from dryer cabinet side
of hinges. Loosen (do not remove) top screws from dryer cabinet
side of hinges.
3.
Lift door off top screws
Lift door until top screws in dryer cabinet are in large part of
hinge slot. Pull door forward off screws. Set door (handle side
up) on top of dryer. Remove top screws from dryer cabinet.
22
4.
Remove screws from hinges
Remove screws attaching hinges to door.
5.
Remove screws from door
Remove screws at top, bottom, and side of door (4 screws) that
hold the inner and outer door together. Holding door over towel
on dryer, grasp sides of outer door and lift to separate it from
inner door. Set outer door aside.
NOTE: Do not pry apart with putty knife or screwdriver.
Do not pull on door seal or plastic door catches.
6.
Switch door catch, bezel, & plug
Catch and bezel
Remove the door catch, bezel, and plug from the inside of the
inner door by squeezing and pulling/pushing them. Place the
door catch, bezel, and plug on the sides opposite from where
they were.
Plug