Engine Start / Stop Switch; Throttle Control Lever; Throttle Safety Lever; Manual Starting Grip - Stiga BC 636 Serie Manual De Instrucciones

3. Insert the end with the groove (Fig. 12.D)
in the protruding tube (Fig.12.B) of the rear
handgrip (Fig. 12.C) and fasten it with the
screw (Fig. 12.E) ensuring it stays locked.
4. Press the pin (Fig. 13.A) and insert
the flexible (Fig. 13.B) in the seat
of the power unit (Fig. 13.C).
5. Release the pin (Fig. 13.A), making
sure it is lowered completely to lock
the end of the tube (Fig. 13.B).
6. Remove the rubber protection (Fig.13.D)
and pass the cables throught it. (Fig.13.E)
7. Open the throttle cable protection device
with the help of a screwdriver (Fig.13.F)
8. Connect the cables (Fig.13.G) with (Fig.13.H)
9. Close the protection device (Fig.13.F)
10. Connect the connectors
(Fig.13.I) with (Fig.13.L)
11. Put the rubber protection back (Fig.13.D)
5. CONTROLS

5.1 ENGINE START / STOP SWITCH

Used to start and stop the engine. The
switch has two positions (Fig. 14.A):
STOP - the engine stops
and cannot be started.
START - the engine can be
started and operated.

5.2 THROTTLE CONTROL LEVER

Used to adjust the speed of the cutting means.
The throttle safety lever (Fig. 14.B) can
only be operated if the throttle safety lever
is pressed at the same time (Fig. 14.C).
The correct working speed is set using throttle
safety lever (Fig. 14.B) to the end of its stroke.

5.3 THROTTLE SAFETY LEVER

The throttle safety lever (Fig. 14.C) allows the
throttle control lever to be used (Fig. 14.A).

5.4 MANUAL STARTING GRIP

Allows the engine to be started
by hand (Fig. 14.I).
5.5 CHOKE CONTROL LEVER
(IF AVAILABLE)
It is used to cold start the engine. The
control features two positions (Fig. 14.E):
Position A - The choke is
disengaged (normal operation
and hot engine start).
Position B - The choke is engaged
(for engine cold start).

5.6 PRIMER CONTROL BUTTON

Press the primer's rubber button
to inject fuel into the carburettor,
thereby making it easier to
start the engine (Fig. 14.F).
5.7 DISPLAY (IF AVAILABLE)
The display (Fig. 14.J) shows
information regarding the machine
operation and maintenance.
Tachometer.
The digits on the display show
the number of engine rpm.
Timer.
The digits on the display show
the machine's hours (H) and
minutes (M) of operation.
Maintenance.
Icon
maintenance is required.
Icon
when the maintenance hourly
threshold is reached.
The frequency and types of
maintenance are summarised
in the "Maintenance Table"
(see chapter 13).
The flashing continues for 1 hour.

6. USING THE MACHINE

IMPORTANT The safety regulations
to follow are described in chap. 2. Strictly
comply with these instructions to avoid
serious risks or dangers.
EN - 9
indicates that no
starts to flash