Detergent Cleaning Precautions; Miscellaneous Safety Precautions - Mi-T-M WP SERIE Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

6 
important safety warnings

detergent cleaning precautions:

.  DO NOT use solvents or highly corrosive detergents or acid type cleaners 
with this pressure washer.  Use only Mi-T-M detergents.
2. KNOW YOUR DETERGENTS! Be prepared to tell a physician exactly
what you are using in the event of an emergency.  Read the Material Safety 
Data Sheet (MSDS) provided with your detergent and all detergent labels. 
Follow  all  appropriate  instructions  regarding  preparation  use,  safety  and 
transportation.  Keep ALL detergents out of the reach of children.
3.  DO NOT use this pressure washer to dispense hazardous detergents.
4.  DO NOT alter the detergent injection feature in any manner not prescribed 
in this manual.  Use only genuine Mi-T-M replacement parts for necessary 
repairs. 

miscellaneous safety precautions:

.  NEVER ALLOW  CHILDREN  OR ADOLESCENTS  TO  OPERATE  THIS 
UNIT!
2.  Read and follow all handling, operations, maintenance and safety instructions 
listed in this manual and the Engine Operator's manual that accompanies 
this unit, and provide such information to ANYONE who will be operating 
this unit.
3.  In freezing temperatures, the unit must always be warm enough to ensure 
there is no ice formation in the pump.  DO NOT start this unit if it has been 
transported in an open or underheated vehicle without first allowing the
pump to thaw.
4.  When connecting the water inlet to the water supply mains, local regulations 
of your water company must be observed.  In some areas the unit must not 
be connected directly to the public drinking water supply.  This is to ensure 
that there is no feedback of the detergents into the water supply.  (Direct 
connection is permitted if a back flow preventer is installed.)
5.  DO NOT allow any part of your body or the high pressure hose to make 
contact with the muffler. Avoid dragging the hose over an abrasive surface
such as cement.  This causes wear and eventual rupturing.
6.  High pressure hoses should be inspected daily for signs of wear.  If evidence 
of failure exists, promptly replace all suspect hoses to prevent the possibility 
of injury from the high pressure spray. If a hose or fitting is leaking , NEVER
place your hand directly on the leak.
7.  DO NOT operate the unit without all protective covers in place.
8.  NEVER run the unit with the governor disconnected or operate at excessive 
speeds.
9.  To  reduce  the  risk  of  injury,  maintain  a  safe  distance  for  persons  while 
operating this unit.  Close supervision is necessary when operating the unit 
near children.
0.  DO NOT leave pressurized unit unattended.  Shut off the unit and release 
trapped pressure before leaving.
.  DO NOT move the unit by pulling on the hose.
WP-Cold Water Direct Driven Operator's Manual

Capítulos

Tabla de contenido
loading

Tabla de contenido