EGO Power+ LM2100SP Manual Del Usuario página 17

ATTACHING/REMOVING THE SIDE DISCHARGE CHUTE
(available separately) (Fig. 11a & b)
WARNING: Do not at any time make any adjustment to
the lawn mower without first stopping the motor, removing the
battery pack and waiting for the blade to stop rotating.
1. Remove the battery.
2. Lift the rear-discharge door.
3. Align the lower edge of the discharge with the groove of the
doorsill and insert it into the slot.
4. Push the top of the discharge and insert it into the mower.
Check to see that it is securely seated in the deck.
5. To remove the side discharge chute, lift the rear-discharge
door, grasp the side discharge chute and pull it out.
6. Release the discharge door and make sure that it rests
firmly against the discharge chute.
SPRING-LOADED CUTTING-HEIGHT ADJUSTMENT (Fig. 12)
WARNING: Do not at any time make any adjustment to
the lawn mower without first stopping the motor, removing the
battery pack and waiting for the blade to stop rotating.
WARNING: Keep your feet away from the deck when
adjusting its height.
The mower can be set to 6 cutting heights between 1-1/2"
(41mm) and 4" (107mm). Choose the proper cutting height
according to the type and condition of the grass.
To raise the blade height
1. Grasp the height-adjustment lever, and move it outwards.
2. Move the lever toward the back of the mower and engage
the lever in the desired cutting-height position on the
mower deck.
To lower the blade height
1. Grasp the height adjustment lever, and move it outwards.
2. Move the lever toward the front of the mower and engage
the lever in the desired cutting-height position on the
mower deck.
11a
11b
12
56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2100SP & LM2100
Groove
Step 2
Step 1
Height-Adjustment Lever
1
2
17