Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PA3500
INTRODUCTION
Thank you for purchasing the DEWALT PA3500 low velocity powder actuated tool. This
tool will provide you with excellent performance provided the steps for proper operation
and maintenance are followed. Powder actuated fastening systems can provide a
cost effective method of attaching fixtures for light duty, static load conditions. The
systems provided by DEWALT consist of specially designed fasteners, installation tools,
and powder loads, which are designed to function in combination to provide optimum
performance. While powder actuated tools can provide one of the fastest
and economical means of fastening, they can also be dangerous if they are not
operated properly.
Prior to operating the PA3500 tool, you must be properly trained in the operation
and maintenance of this tool and be issued a DEWALT Qualified Operator Card. When
using the tool, you must have this card in your possession. As part of the training
process, you should read and understand the contents of this instruction manual
especially the safety precautions.
Powder actuated tools may be operated only by properly trained operators as
described in ANSI Standard A 10.3, Safety Requirements for Powder Actuated
Fastening Systems. For complete tool operation details, contact your local DEWALT
Branch office or distributor for training.
Remember, safety begins with you! It is your primary responsibility when operating
this tool. Failure to follow the proper operating, maintenance, and safety procedures
can result in serious injury or death to yourself or bystanders. In addition to the training
provided, you should be familiar with any local, state, and federal regulations. If you
have any questions that are not covered in this manual, contact your local DEWALT
Branch office or distributor.
SIZE RANGE
1/2" to 3" pin lengths, .27 caliber powder loads
TOOL DESCRIPTION
The PA3500 is a power adjustable, low velocity, semi-automatic .27 caliber tool
which can be used to install .300 head drive pins, 8mm head drive pins and 1/4"-20
threaded studs, up to 3" in total length. The PA3500 is designed for high speed and
repetitive volume applications. It includes a power adjuster, allowing the operator to
effectively decrease the power level of the load being used.
TECHNICAL DATA
TOOL BODY
Precision Cast Aluminum
LOAD TYPE
.27 Caliber in a 10 Load Strip
Ballistic Point Drive Pin, .300 Head Drive Pin, 8mm Head Pin, 1/4"-20 Threaded Stud
PA3500 SELECTION GUIDE
CAT #
52019-PWR
52103-PWR
52108-PWR
52110-PWR
MAX PIN LENGTH
1/2" to 3" Total Length
TOOL WEIGHT
5 lbs.
PIN TYPE
DESCRIPTION
PA3500 Powder Tool (Deluxe Kit):
Tool, Spall Guard, 5mm Allen Wrench,
2 Annular Balls, 2 Sear Clips and Case
PA Piston Flat End with Ring
Guide 2/F-3
Base Plate 2/S-13
EN
2
TOOL LENGTH
13-5/8"
POWER LEVEL
Brown (2), Green (3),
Yellow (4), Red (5)
CTN
1
1
1
1
Tabla de contenido
Solución de problemas
