Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5. SAFETY
Quick Release Features
Operating the Quick Release Trim Loop:
To activate the Quick Release Trim Loop: Grasp the handle of the quick
release trim loop and force it up the QRTL line, away from your body.
Important:
It is your responsibility to maintain the proper working
order of the quick release mechanism. Always inspect this piece prior
to launching your kite. Make sure the trigger mechanism is properly
seated before you ride, and occasionally while on the water. There are
two ways to do this:
1. Grasp the handle and pull it towards your body.
2. Briefly unhook from the loop, and then hook back in.
Release Pics 1-4:
To release, grasp the handle and force it away from
your body to open the loop.
Reload Pic 5:
Released QRTL.
Reload Pic 6:
Slide the arm through the stainless steel loop at the end
of the QRTL.
Reload Pic 7:
Slide the handle down the line over the arm.
Note: You MUST test your Quick Releases before every session in
order to get used to the way they work. This is the only way for you
to be able to use them fast enough in case of emergency. Remember
that the Quick Release devices have a limited lifetime and you must
change them after 250 hours
of kiting. Our Quick Releases are
developed and designed to be
used by a rider of 80kg or less.
Stopper Warning:
BE AWARE THAT USING THIS ITEM CAN CAUSE SERIOUS INJURY OR DEATH.
Only use this Stopper if you are an expert kiteboarder and fully under-
stand the consequences of using this item. The Stopper is NOT a safety
system and will greatly inhibit the kite from reaching its full depower
range. DO NOT install this item if you are not an expert kiteboarder. When
you launch your kite or when you are getting close to the beach or any
obstacle on the water, you must ALWAYS put your stopper at it' s highest
position (against the pulley).
12
naishkites.com
To Reload:
5
To Release:
1
3
6
2
4
7
Tabla de contenido
