Tabla de contenido
Idiomas disponibles
Idiomas disponibles
A safety rope which already hold the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!
Connection with the mains
Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
OPERATION
After you connected the effect to the mains, the FF-1 starts running.
On the rear panel of the FF-1, you can find a 3-step mode-selector with the following functions:
0 Static light
I Continuous beam-movement
II Sound-controlled beam-movement
Connect the remote control with the Remote Control-socket.
CAUTION: The escape nozzle will heat up during operation. Therefore do not touch the nozzle until it
has cooled down completely.
DANGER TO LIFE!
International
L
N
20/40
After a certain warm-up time, the device is
ready to operate. Then the stand-by lamp of
the remote control lights up. By operating the
smoke switch on the remote control the smoke
emission starts. It may happen that the stand-
by lamp turns off and the smoke emission
stops. In this case the device is heating up
again and will be ready to operate in approx.
1-2
min.
This
process
appropriate vaporization temperature and the
best
smoke
emission
temperature is regulated by a high quality
thermostat.
51701897_V_1_0_2643.DOC
guarantees
an
possible.
The
Tabla de contenido
