Connection With The Mains; Operation - EuroLite N-10 Manual Del Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

For overhead use, always install a safety-rope that can hold at least 12 times the weight of the fixture. You
must only use safety-ropes with screw-on carabines. Pull the safety-rope through the attachment eyelet on
the rear panel of the device and over the trussing system or a safe fixation spot. Insert the end in the
carabine and tighten the safety screw.
Use the safety-rope exclusively as a closed ring. Never use by only securing at each end. The maximum
drop distance must never exceed 20 cm.
A safety rope which already hold the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!

Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!

OPERATION

Switch the device on via the power switch. Connect the remote control with the Remote Control-socket.
CAUTION: The escape nozzle will heat up during operation. Therefore do not touch the nozzle until it
has cooled down completely.
DANGER TO LIFE!
International
L
N
17/35
After a certain warm-up time, the device is
ready to operate. Then the stand-by lamp of
the remote control lights up. By operating the
smoke switch on the remote control the smoke
emission starts. It may happen that the stand-
by lamp turns off and the smoke emission
stops. In this case the device is heating up
again and will be ready to operate in approx.
1-2
min.
This
process
appropriate vaporization temperature and the
best
smoke
emission
temperature is regulated by a high quality
thermostat.
51701943_V_1_0_3046.DOC
guarantees
an
possible.
The
Tabla de contenido
loading

Tabla de contenido