Tabla de contenido
Idiomas disponibles
Idiomas disponibles
STARTING OPERATION
Install the device on a plane surface.
The fluid tank of the device needs to be filled with smoke fluid before starting up operation and always
disconnected from the mains as fluid could be spilled.
Only use quality smoke fluids available at your dealer. We recommend high-quality Eurolite smoke fluids (e.
g. EUROLITE Smoke Fluid "P" Profi, 1 l). You must not use substances that are classified as "dangerous
working material" or "inflammable fluids".
If fluid should get into the interior of the device, disconnect from mains immediately and consult a technician.
Fill the chamber with regular ice cubes.
Firmly attach the included tube to the drainage outtake. Connect the end of the tube to the drainage
container.
When the chamber is filled, gently put the cover back and tighten with the fixation screw.
Firmly attach the remote control cable to the proper input on the rear of the machine.
Attention: Drain the water in regular intervals (ca. every 45 minutes).
Installation
Install the device in a well-ventilated area. The operation in an unsufficiently ventilated room can lead to a
condensation of the smoke fluid. The resulting slippery surface can cause accidents. Keep a minimum
distance of 20 cm around and above the device.
Furthermore do not orientate the escape nozzle directly in the direction of the audience's eyes. In order to
create a good effect, there should be a distance between the device and the audience of at least 1.5 m.
Only install the smoke-machine on scratch resistant and water resistant surfaces.
This device is only constructed for a standing installation.
Connection with the mains
Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
(6) Ventilation fan
(7) Drain tap
(8) Drain switch
(9) Remote control IN
(10) Remote control OUT
(11) DMX IN
(12) DMX OUT
(13) DIP-switches
(14) Power supply and fuse
(15) Power switch
17/40
00033330.DOC, Version 1.1
Tabla de contenido
