Tabla de contenido
Idiomas disponibles
Idiomas disponibles
C
† . Mounting Parts
(Part # SDC-MOUNTING KIT)
.
6 Spacers
½"
¼"
"
/
6
/
6"
B.
Screws
"
½"
¼"
C.
Washers
. Mounting Template (in box)
You will also need:
• Tape
• Ruler (or you may cut out the ruler provided on the template)
• Electric drill with a ¼" drill bit
6
B
GETTING ST RTED
• Remove all packing material, labels and any stickers.
• Remove and save literature.
• Unpack mounting parts and set them aside in a safe place where they will not
roll away or get lost.
Important: Do not attempt to operate appliance until it is properly installed.
CHOOSE LOC TION
When choosing your location, consider the following:
• DO make sure to mount within reach of an electrical outlet.
• DO consider your normal work patterns in the kitchen when choosing
location.
• DO NOT mount over any heating or cooking appliance such as your range or
oven.
• DO NOT mount over or near a sink.
• DO NOT mount under, in front of or behind any under-cabinet light fixtures.
Note: If you are mounting multiple †SpaceMaker™ appliances, they should not
be mounted flush to one another. llow at least 4" of space between appliances
for adequate cooling.
Note: If you are connecting this appliance to the receptacle of another
†SpaceMaker™ appliance such as the toaster oven or coffeemaker, make sure you
can easily unplug the appliance following use.
DETERMINE C BINET TYPE
Prior to installation, determine if your cabinet has a flat bottom (B) or an
overhang molding (C). If your cabinet is flat, follow ST ND RD INST LL TION;
if the cabinet has an overhang molding, refer to OVERH NG MOLDING
INST LL TION.
B
ST ND RD INST LL TION (FL T C BINET)
Important: lways wear protective glasses or goggles to prevent injury when
drilling.
1. Clear countertop under installation area to avoid getting dust or debris on other
appliances or items. Open cabinets and remove contents to make mounting
easier.
2. Clean both the underside and topside of the bottom panel of the cabinet.
C
7
Tabla de contenido
