Toto EcoPower STD TELS10 Serie Manual De Instrucciones Y Del Propietario página 6

Grifos automáticos
Ocultar thumbs Ver también para EcoPower STD TELS10 Serie:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

2.
For fastening to wood , drill three (3)
pilot holes 7/64" (2.7mm) in diameter at
marked locations.
For fastening to drywall or tile , drill three
(3) holes 3/16" (5mm) in diameter and
insert anchors until fush. Tap lightly with a
hammer if needed.
3.
Feed the supply tube and sensor co rd
through the 5/8" (16mm) hole in center.
Place spout against wall and fasten
securely with the provided screws.
4.
Fasten the escutcheon to the bracket
until hand-tight.
To Install Gooseneck Wall-Mounted Models (Ill. 7, 8 & 9):
NO TE: The addition of a 1 x 6" or plywood
bracing behind the mounting location is
highly recommended for drywall/hollow
wall installations. The overall maximum
wall thickness is 2" (50mm).
1. Drill a 1-1/8" (29 mm) hole at the desired
location for the mounting bracket. Put
the mounting bracket through a hole in
the wall with the set screw hole located
at 12 o'clock. Mark the location of the
set screw hole on the wall and remove
the mounting bracket.
For sheet metal surface: Drill a 3/16" (5mm)
hole at the marked location.
NO TE: Drill bits (not supplied) for hard materials
may be required.
For a drywall/hollow wall surface: Drill a 1/4"
(6.5 mm) hole at the marked location,
and install the included wall anchors.
NO TE: Confrmation of wall strength is
highly recommended before drilling.
2. Install the mounting bracket using the
rubber washer, brass washer, and both
brass nuts on back side of the installation
surface. Install the included set screw
(for sheet metal installation) or 30 mm
machine screw (for drywall installations).
3. Pass the hose and sensor cord through
the mounting bracket, slide the spout
base over the mounting bracket and
tighten the set screw to secure the spout
to the mounting bracket.
INSTALLATION PROCEDURE
STEP 8
ill. 5
2 x 4
Stringer
2 x 4
Studs
ill.6
ill. 7
Hole for set screw/machine
screw and wall
anchor
Hole for mounting bracket
ill. 8
Plywood
(not required for sheet
metal installation)
Set Screw
(Sheet metal) or
Machine Screw
(Drywall/ Hollow
Wall)
ill. 9
Drywall Installation
M5x30
Machine
Screw
and
Wall
Anchor
Set Screw
Drywall
5
Finished Wall
5/8" Hole for
spout
Holes for screws/
anchors
Escutcheon
Ø 3/16" (sheet metal surface)
Ø 1/4" (drywall/hollow wall)
Ø 1-1/8"
Brass Washer
Rubber Washer
Nuts (2)
Sheetmetal Installation
1x6 or Plywood
Thin Wall
Bracing
(Sheet
Metal
Surface)
M5 Set
Screw
Mounting
Mounting
Bracket
Bracket
Set Screw
Tabla de contenido
loading

Tabla de contenido