Tool Operation Check - Bostitch BTFP12182 Manual De Operación Y De Mantenimiento

BTFP12182 ADJUSTMENTS
STAPLE LENGTH ADJUSTMENTS:
This tool comes supplied for use with 38mm staples for stapling two
thicknesses of triple flute board. The adjustment plate can be moved to
achieve different levels of penetration varying on the total thickness of
the boards (Fig 7). Loosen the nuts (Fig 6) and adjusting the plate as
shown in the table below. If adjustments do not give a satisfactory clinch,
alternative clinchers may needed to be fitted and adjustments made in
accordance with the following table.
Note: Additional clinchers are not included and should only be fitted by the
authorized agents of Bostitch or by other experts, giving due regard to the
safety, operating and maintenance instructions in this manual, the Safety and
Operating Instructions Manual and in the Tool Technical Data.
Staple Leg
Length
1" (25mm)
1-1/8" (28mm)
1-1/4" (32mm)
1-2/8" (35mm)
1-1/2" (38mm)

TOOL OPERATION CHECK:

CAUTION: Remove all fasteners from tool before performing tool operation check.
1. TRIGGER OPERATED TOOL:
A. With finger off the trigger, hold the tool with a firm grip on the handle.
B. Place the nose of the tool against the work surface.
C. Pull the trigger to drive.
THE TOOL WILL CYCLE EACH TIME THE TRIGGER IS PULLED!
THIS IS A FULL CYCLE TOOL. PULL THE TRIGGER, AND CLINCHERS WILL DISCHARGE
AND RETRACT
Anvil Adjusting Plate
Size Position
25 5
4
32 5
4
38 6
Penetration
Depth
.59" (15mm)
.59" (15mm)
.71" (18mm)
.71" (18mm)
.95" (24mm)
-6-
FIG.6
Adjustment
plate
FIG.7
Front
screw