Tabla de contenido
•
Manage the access point from the
computer via the Unified Wireless
Switch or Wireless Controller: Connect
the access point to a Unified Wireless
Switch or Wireless Controller. Connect
your computer to the same network as
that of the Unified Wireless Switch or
Wireless Controller. Log in to the Unified
Wireless Switch web administration page
or Wireless Controller web administration
page. For the default login information
please see Unified Wireless Switch user
manual or Wireless Controller user manual.
Unified Wireless
DWL-7620AP
Wireless Controller
Mounting Options
You can mount the DWL-7620AP access
point on any of the following types of
surfaces:
• Solid surface wall or ceiling
• Tabletop
Cable Requirement
Use a CAT 5 cable with an even sheath.
The Ethernet ports on the DWL-7620AP
access point cannot accept a CAT 5 cable
that has an uneven sheath; the RJ-45
connector on the cable will not fit properly into
the receptacle on the access point.
Wall Installation Recommendations
If you plan to install the DWL-7620AP on a
wall or other vertical surfaces, orient the top
of the access point (the side with the LEDs)
toward the intended coverage area. The
radio antennas transmit through the top of
the access point but not through the bottom
(where the bracket is).
Warning: The DWL-7620AP is designed to
receive PoE power only from an 802.3at-
compliant source, or from a D-Link-approved
power adapter. Connecting an access point
to a Power over Ethernet (PoE) device that
is not approved by D-Link can damage the
equipment.
4 D-Link DWL-7620AP Quick Install Guide
Computer
Switch
or
Warning: This product is to be connected only to
PoE networks without routing to the outside plant.
The equipment power cord must be connected to
a socket-outlet earthling connection.
Avertissement: Le DWL-7620AP est concu
pour recevoir de l'alimentation PoE uniquement
a partir d'une source compatible 802.3at ou d'un
adaptateur secteur approuve par D-Link. La
connexion d'un point d'acces a un peripherique
Power over Ethernet (PoE) non approuve par
D-Link peut endommager l'equipement.
Avertissement: Ce produit doit etre connecte
uniquement aux reseaux PoE sans acheminement
vers l'installation externe. Le cordon d'alimentation
de l'equipement doit etre branche sur une prise de
terre avec prise de courant.
Mounting Using Anchor Screws
Installation
1. Place the plastic wall mounting ring on a
wall or ceiling. Mark the points where you
will insert the screws, then remove the
mounting ring.
2. Drill holes in the marked points and
insert the plastic wall anchors.
3. Use the supplied screws to attach the
mounting ring to the wall.
4. Plug the CAT 5 cable into the LAN port on
the access point.
Tabla de contenido
