Tabla de contenido
Interfaces
Power Receptor
LAN 2 Port
Figure 2. DWL-7620AP Rear Panel
Reset Button
Power Button
Installation
Power on the Access Point
To power on the DWL-7620AP, you can use
one of the following methods:
•
Connect the supplied power adapter.
•
Plug one end of an Ethernet cable into
the LAN 1 port of the DWL-7620AP and
the other end into a port on a PoE switch
or injector.
Kensington Port
Console Port
LAN 1 Port (PoE)
OR
Configure the Access Point
To set up and manage the DWL-7620AP,
use one of the following methods:
•
Manage the access point from
the computer: Connect the access
point and your computer directly via a
straight-through Ethernet cable. Ensure
your computer is configured with a
static IP address in the 10.90.90.0/24
subnet. Launch a web browser, type the
default IP address of the access point
(http://10.90.90.91), then press Enter.
To log in, use the default login
information:
Username: admin
Password: admin
DWL-7620AP
•
Manage the access point from the
computer via the switch or router:
Connect the access point and your
computer to the same switch or router.
If the access point did not acquire an
IP address from a DHCP server on
the network, enter 10.90.90.91 in the
address field of your browser, which
is the default IP address of the access
point. If you used a DHCP server on
your network to automatically configure
network information for the access point,
enter the new IP address of the access
point into the web browser. To log in, use
the default login information:
Username: admin
Password: admin
Switch or
DWL-7620AP
D-Link DWL-7620AP Quick Install Guide 3
Computer
Computer
Router
Tabla de contenido
