Tabla de contenido
Idiomas disponibles
Idiomas disponibles
FEATURES
2
1
8
KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
9
safety requirements.
1. OUTFEED TABLE.
2. FENCE.
3. CUTTERHEAD GUARD.
4. ON/OFF SWITCH.
5. INFEED TABLE.
6. INFEED TABLE RAISE/LOWER HANDWHEEL.
7. CUTTING DEPTH LOCK.
8. OUTFEED TABLE LOCK HANDLE
9. DUST PORT.
10. MOBILE BASE FOOT PEDAL.
UNPACKING
IMPORTANT: The machine is heavy, two peo-
ple are required to unpack and lift. Use a safety
strap to avoid tip over when lifting machine.
Check shipping carton and machine for dam-
age before unpackaging. Carefully remove
packaging materials, parts and machine from
shipping carton. Always check for and remove
protective shipping materials around motors
and moving parts. Lay out all parts on a clean
work surface. Remove any protective materi-
als and coatings from all of the parts and the
jointer.
The protective coatings can be removed by
spraying "Multipurpose lubricant" on them
and wiping it off with a soft cloth. This may
need to be redone several times before all of
the protective coatings are removed complete-
ly. After cleaning, apply a good quality paste
wax to any unpainted surfaces. Make sure to
buff out the wax before assembly. Compare
the items to inventory figures; verify that all
items are accounted for before discarding the
shipping box.
22
4
3
5
6
7
10
WARNING: If any parts are missing, do not
attempt to plug in the power cord and turn
"ON" the machine. The machine should only
be turned "ON" after all the parts have been
obtained and installed correctly.
A.
Cutterhead
guard.
B.
Infeed
table
handwheel.
C. Outfeed table
adjustment knob.
D. Fence locking knob.
E. Fence adjusting knob.
F. Knob washer.
G. Special nut.
H. Foot pedal.
I. Wheels (2).
J. M8 flat Washer (2)
K. M8x50mm hex head
screw (2).
L. Leveling feet (2).
M. M8 hex flange nut (2).
N. M8 x 20mm car-
riage bolt (2).
O. Cutterhead Pulley
guard.
P. V-belt.
Q. Dust port.
R. Push Paddles (2).
S. Power switch.
T. Hex wrenches (4).
U. Open end wrench.
V. Sprig pin.
X. M10 flat washer (3).
Y. M10 lockwasher (3).
Z. M10 x 25mm hex
socket head cap screw
(3)
Aa. M6 x 10mm pan
head screw.
Bb. M6 x 15mm hex
socket head cap screw
(2).
Cc. M6 external tool
washer (2).
Dd. M6 x 8mm pan
head screw (4).
Ee. M6 x 10mm pan
head flange screw (4).
C
D
A
B
F
G
H
I
J
N
M
O
P
R
S
V
Z
Y
X
Aa
Ee
Dd
Cc
E
K
L
Q
T
U
Bb
Tabla de contenido
