Tabla de contenido
Idiomas disponibles
Idiomas disponibles
• Be careful with the sparks detached of the
disc when work. Hold the grinder such way
that the sparks fly away of you, other persons
or flammable materials.
• Don't touch the work piece immediately af-
ter of the operation, could be very hot and can
cause hurts.
THE KICKBACK
The kickback is a sudden reaction. The punc-
tured or hooked produces a quick decrease
speed rate causing loose control of the tool
which is directed towards the side which is the
operator.
The kickback is the result of an inappropri-
ate tool use or an incorrect operation. Can be
avoided following these instructions:
1. Keep a firm grip with both hands on the
tool. Position your body properly to resist the
force of kickback. The operator can control
torque reactions if the correct warnings are
taken.
2. Never place your hand close to the rotating
accessory. It can cause a kickback over your
hand.
3. Never place your body on the kickback area;
the kickback will propel the tool to the oppo-
site direction of the rotation abrasive disc.
4. Use extra care when working with edges.
These tend to engage the disc.
5. Don't use the tool with cutting saws. These
produce kickback.
FEATURES
KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
5
1. SWITCH.
2. LOCK-ON BUTTON.
6
1
2
3
4
E N G L I S H •
3. ANTI-VIBRATION HANDLE SIDE.
4. DISK STORAGE.
5. SPINDLE LOCK BUTTON.
6. HANDLE.
ASSEMBLY INSTRUCTIONS
WARNING: Remove the grinder from the
carton and examine it carefully. Do not discard
the carton or any packaging material until all
parts are examined.
LATERAL HANDLE
The
lateral
handle
must be used always
that the machine is
running.
Screw
the
lateral handle inside
the holes, could be on
the right, left or superior side. Your choice is
determined by your convenience and ability to
keep the complete control.
GUARD
The guard is a security
device to prevent in-
juries caused by pieces
of abrasive disc. When
installing the guard,
make sure the raised rib aligns with the slot on
the cover of the gearbox. Then turn to the left
the protector until stays in the correct position.
Before the operation, make sure that the guard
is locked on place. Release the fixed screws, the
guard can be adjusted to the desired position.
Once done this, adjust the fixation screw.
INSTALL AND REMOVE THE ABRASIVE DISC
To Install:
1. Make sure that the guard is in its place.
2. Place the internal
adapter on the shaft.
Make sure that it is
placed on the two
plane surfaces.
3. Check the abrasive
disc speed. Don't use
a disc which speed
range is less than the
indicated on the label machine.
4. Press the spindle lock button, to prevent
movement.
U s e r's m a nu al
11
Tabla de contenido
