Tabla de contenido
Idiomas disponibles
Idiomas disponibles
HANDWHEEL ASSEMBLY
The purpose of the handwheels is to raise and
lower the outfeed and infeed tables. The pro-
cedure for installation is the same for both the
infeed and outfeed sides of the jointer.
To install:
1. The key (Fig.14-A)
pan head screw (B)
and flat washer (C)
should already be at-
tached to the shaft.
2. Remove the pan head screw and flat washer.
Remove the tape from the key.
3. Insert the handwheel onto the shaft making
sure that the notch in the handwheel lines up
with the key on the shaft.
4. Fasten the handwheel to the shaft using pan
head screw and flat
washer removed in
step 2.
5. Thread the handle
(Fig.15-D)
into
the
threaded hole (E) in
the handwheel.
INFEED TABLE ADJUSTMENTS
To raise or lower the infeed table, loosen in-
feed table lock handle (Fig.16-B) and turn the
table raising and lowering handwheel (A) until
the table is at the desired position and tighten
infeed table lock handle.
D
C
Fig.16
INFEED POSITIVE STOP
There is a safety fea-
ture that will not al-
low the infeed table
to drop below a 1/8-in
depth of cut. This stop
(Fig.17-A) is located
on the rear of the
jointer.
C
A
B
Fig.14
D
E
Fig.15
B
A
A
Fig.17
E N G L I S H •
Once the jointer hits a depth of 1/8", the spring
loaded knob snaps into a hole in the infeed
table. To make the infeed table go lower than
this, you will have to pull out on the knob as
you lower the table.
OUTFEED TABLE ADJUSTMENTS
WARNING: DISCONNECT MACHINE FROM
POWER SOURCE.
The outfeed table must be exactly level with
the knives when the knives are at their high-
est point of revolution. To move the outfeed
table, loosen outfeed table lock handle (Fig.16-C)
and turn the table raising and lowering hand-
wheel (D) until the table is level with the
knives. When the outfeed table is exactly level
with the knives at their highest point of revolu-
tion, tighten outfeed table lock handle.
ATTACHING CUTTERHEAD PULLEY GUARD
WARNING: DISCONNECT MACHINE FROM
POWER SOURCE.
The cutterhead pul-
ley guard is attached
to the jointer using
four M6 x 10mm Phil-
lips pan head flange
screws (Fig.18-A).
ADJUSTING FENCE POSITIVE STOPS
The fence on your jointer is equipped with
positive stops at the most used fence positions
of 90 degrees and 45 degrees in and out.
To check and adjust the positive stops, proceed
as follows:
WARNING: Make certain that the machine is
disconnected from the power source.
1. Position the fence at 90 degrees to the table
by loosening the bevel lock handle (Fig.19-D)
and moving the fence until 90 degree stop
screw (A) hits the stop (E).
A
B
E
Fig.19
U se r's m a nua l
Fig.18
A
C
D
25
Tabla de contenido
