Maintenance; Setting The Angle Of The Blade - Sima DAKAR MK45 Manual De Instrucciones

10. MAINTENANCE

The table saws require a simple maintenance as per the following operations:
• Change the tray water and clean the machine as much as needed. The tray has a tap for this use. It is
necessary to fill the tray with water until the pump is covered with water.
Although the cooling pump has a filter cap, it may get in dirt and debris inside of the cut material to block the
•
propeller. To prevent this, periodically run the pump in a container with clean water for several minutes. If
necessary, unscrew the filter cap and clean the propeller until it turns freely.
• Remove all possible residuals of cut materials that can cling into the rolling tracks of the cutting bridge.
• Replace as soon as possible electrical cables that cause power cuts, breaking or any other disrepair.
• If the machine is not covered, wrap it with an impermeable cloth.
• At the end of each day, unplug the machine.
• Maintenance operations should be performed by people who the machine and its functioning.
ATENCION: before performing any maintenance or cleaning operations, the electricity cable should be
unplugged.
In case you observe any anomalies or mal functioning, let a technician check the machine.
Take into account the safety recommendations mentioned in this manual.
It is prohibited to independently make any change in some parts, components or characteristics
of the machine. SIMA, S. A. shall in no case be responsible for the consequences that may derive
from a breach of these recommendations.

10.1 SETTING THE ANGLE OF THE BLADE

The cutter are shipped well regulated so that when mounting the blade cut at an angle of 90 ° with the car in
the vertical and horizontal. If for some unforeseen blow or any other cause to be off, go to the nearest service center
for repair.
16
ENGLISH