Transportation; Electrical Plugging And Adjusting The Disk Rotation Sense - Sima DAKAR MK45 Manual De Instrucciones

3. TRANSPORTATION

After unpacking the machine, it can be move it into the work place manually by two people.
It is recommended to empty the water from the tray before moving the machine to avoid splashing or
spillage. It is also necessary to block the car to avoid unexpected slip during transport. Check also that they are fully
tightened the screws holding the legs to the tray to avoid dislodging the raising machine.

4. ELECTRICAL PLUGGING AND ADJUSTING THE DISK ROTATION SENSE

Upon receipt of the machine, make sure the network electrical tension is adequate before plugging the machine. The
electrical tension is to be found on the voltage indication next to the switch of the machine.
WARNING: Never plug the machine to electricity, in case the network power tension is not the adequate
as the engine would undergo irreparable damages.
Once you have realised the previous steps and before placing the disk and manipulate the motor, it is
necessary to check and adjust the rotation of the motor axis correctly, you have to plug the machine to the electricity
and start it up, watching the rotation direction that must be clockwise.
If necessary and with three-phase motors, you can change the rotation direction swapping the two phase wires in the
aerial or in the peg of the feeding extension cord.
WARNING: Never manipulate power supply cables or any other electrical
equipment on the machine before you unplug the machine from electricity.
WARNING: Unplug the machine from the network before proceeding to change the
position of the bridge plates on the engines. You should also proceed to change the
stickers indicating the supply voltage, so there will
machine rated voltage.
always be indicated on the
7
ENGLISH