Hazard: Explosion Or Fire - WAGNER HT400 El Manual Del Propietario

Important Safety Information • Read all safety information
before operating the equipment. Save these instructions

HazaRD: eXPLOSION OR FIRe

This heat gun produces extremely high temperatures (as high as 1200º F). It must
be used with caution to prevent combustible material from igniting.
PReveNTION:
1. Keep the gun in constant motion. Do not stop or dwell in one spot.
2. Use extreme caution if the other side of the
material being scraped is inaccessible, such as
house siding. The hidden side could catch on fire
if it becomes too hot. Some buildings contain
highly flammable materials behind siding, floors,
facia, soffit boards and other panels. Check these
areas before applying heat and do not use a heat
tool if flammable materials are present or if you are
unsure of the hidden material.
3. Do not use near surfaces with cracks or near metal
pipes or flashing. Heat may be conducted behind the work surface and ignite hidden
material. The ignition of hidden materials may not be readily apparent and can result in
property damage and injury.
4. Do not use electric tools in the presence of flammable liquids or gases.
5. Do not use near combustible materials such as dry grass, leaves, and paper which can
scorch and catch fire.
6. The nozzle becomes very hot. Do not lay the heat gun on flammable surfaces when
operating the gun or immediately after shutting the gun off. Always set the gun on a flat,
level surface so that the nozzle tip is directed upwards and away from the supporting
surface.
7. Do not touch the nozzle until the tool has cooled.
8. Do not use the heat gun as a hair dryer.
9. Tools and paint scrapings become very hot. To avoid burns, use work gloves when
scraping.
10. Always treat the hot air units with the same respect as an open flame.
HazaRD: eLeCTRIC
May cause property damage, severe injury or loss of life.
PReveNTION:
1. Do not disassemble the heat gun.
2. Do not work in wet areas or expose the heat gun to rain.
3. Guard against electric shock by preventing body contact with grounded surfaces such as
pipes, radiators, ranges, aluminum ladders or other grounded devices.
4. Do not abuse the electric cord. Never carry the heat gun by the cord or yank on the cord
to disconnect if from the power supply. Keep the electric cord away from heat, oil and
sharp edges. Inspect the cord for wear or damage regularly.
5. Use only extension cords rated for outdoor use. If an extension cord is damaged or
otherwise unsuitable for use, replace it with a new cord.
6. This heat gun has a polarized plug. One blade is wider than the other. To reduce the risk
of electric shock, this plug is intended to fit in a polarized outlet only one way. If the plug
does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician. Do not modify the plug in any way.
4
English
Inside
Wall
Facia
So t
Siding