Idiomas disponibles
Idiomas disponibles
1. Unbolt the tailgate and supports (FIG. 9-1).
2. Remove and save 2 tailgate strikers
and washers (FIG. 9-1).
3. Drill out the center hole of each
washer, removed with striker,
using .406" drill bit.
4. Insert an M10 x 25 hex head
bolt (Kit item), with drilled-out
washer, in each hole where
tailgate strikers were removed
(FIG. 9-2).
5. Support rear bumper and trailer
hitch (FIG. 9-3) before unbolting the
bumper brackets and trailer hitch.
NOTE: When liftgate is installed on
the truck the tailgate, trailer
hitch, and rear bumper
cannot be reinstalled.
6. Unbolt and remove rear bumper,
bumper brackets, and trailer hitch
(FIG. 9-3).
LIFT CORPORATION Sht. 9 of 54 DSG#
PREPARING PICKUP TRUCK
M-15-10
TAILGATE
STRIKER & WASHER
(2 PLACES)
SUPPORT
(2 PLACES)
REMOVING TAILGATE & SUPPORTS
FIG. 9-1
M10 X 25 BOLT &
DRILLED .406" WASHER
(2 PLACES)
REPLACING STRIKERS WITH
BOLT & WASHER
FIG. 9-2
BUMPER MOUNTING
BRACKETS
REMOVING REAR BUMPER
FIG. 9-3
Rev. D Date: 09/21/18
RUBBER PAD
(REF)
TAILGATE
HINGE (REF)
TAILGATE
TRAILER
HITCH
REAR
BUMPER
