Idiomas disponibles
Idiomas disponibles
1. Remove mounting kits shipped with liftgate. Refer to
kits on Sheets 1 through 4. Verify mounting brackets
are the correct brackets for this installation.
`
Liftgate will not stand upright without the shipping angles. Before removing the
angles, make sure Liftgate is supported with forklift or pallet jack. Injury & prop-
erty damage could result if Liftgate falls over.
2. Support Liftgate on ship-
ping pallet with forklift or
pallet jack. Unbolt and
remove cover from the
main frame housing. Then,
unbolt shipping angle from
each column on the Liftgate
(FIG. 6-1). Save shipping
angles to use for lower
mounting brackets.
3. Unbolt bracket plates
from bottom of main
frame housing (FIG. 6-2).
Save the plates to use for
lower mounting brackets.
LIFT CORPORATION Sht. 6 of 54 DSG#
PREPARE LIFTGATE
5/16" HEX NUT,
5/16" FLAT WASHERS
(3 PLACES)
BRACKET PLATE
(2 PLACES)
3/8" FLAT WASHER
(2 PLACES)
CAUTION
!
3/8"-16 BOLT,
3/8" LOCK WASHER,
LH COLUMN
COVER
REMOVING SHIPPING ANGLES
3/8"-16 BOLT
(2 PLACES)
REMOVING BRACKET PLATES
(PLATFORM NOT SHOWN)
FIG. 6-2
M-15-10
Rev. D Date: 09/21/18
3/8"-16 NUT
(4 PLACES)
SPACER
(2 PLACES)
RH COLUMN
FIG. 6-1
ANGLE
(2 PLACES)
