EINHELL GC-PM 51/2 S HW B&S Manual De Instrucciones página 24

result in vibrations, causing further damage to the
mower.
Warning! Risk of injury when working with a da-
maged blade.
7.2.3 Axles and wheel hubs
Grease should be applied to the axles and wheel
hubs once per season.
To do so, remove the wheel caps with a screwdri-
ver and loosen the fastening screws on the
wheels.
7.2.4 Care and adjustment of the actuator
cables
Oil the actuator cables at regular intervals and
check that they move easily.
7.2.5 Inspecting the V-belt
Remove the blade as described in 7.2.2.
To inspect the V-belt you must remove the V-belt
cover (Fig. 9/Item 5b).
7.2.6 Repairs
After carrying out any repair or maintenance
work, ensure that all safety parts are installed and
in perfect condition.
Keep potentially hazardous parts out of reach of
other persons and children.
Note! In accordance with the German Product
Liability Act, we are not liable for any damages if
they result from improper repairs to the product or
if parts are replaced by items other than genuine
parts or parts approved by us. Furthermore, we
are not liable for any damages if they result from
improper repairs to the product. Arrange for your
customer service or an authorized workshop
to do the work. The same applies to accessory
parts.
7.2.7 Operating times
Please observe the regulations concerning lawn
mower operating times, which may differ from
town to town.
7.3 Preparing the mower for long-term
storage
Warning! Do not empty the petrol tank in enc-
losed areas, near fire or when smoking. Petrol
fumes can cause explosions and fire.
1. Drain the petrol tank using a petrol extraction
pump.
2. Start the engine and run it until the tank and
fuel line are completely empty and the engine
GB
The enclosed engine manual from Briggs &
Stratton provides maintenance information
and maintenance interval information on the
engine.
3. Clean the cooling fins of the cylinder and the
4. Be sure to clean the entire equipment to pro-
5. Store the equipment in a well-ventilated
7.4 Preparing the mower for transport
Warning! Do not empty the petrol tank in enc-
losed areas, near fire or when smoking. Petrol
fumes can cause explosions and fire.
1. Drain the petrol tank using a petrol extraction
2. Always let the engine run until it has used up
3. Empty the engine oil from the warm engine.
The enclosed engine manual from Briggs &
Stratton provides maintenance information
and maintenance interval information on the
engine.
4. Remove the spark plug connector from the
5. Clean the cooling fins of the cylinder and the
6. Unhook the starter cable from the hook (Fig.
7. Wedge a few layers of corrugated cardboard
8. Secure the load sufficiently so that it cannot
www.sidirika-nikolaidi.gr
- 24 -
stalls.
housing.
tect the paint.
place.
pump.
the remainder of petrol in the tank.
spark plug.
housing.
3c). Slacken the connection shown in Fig. 3b
on the left and right of the push bar and swing
down the upper push bar. Make sure that the
actuator cables do not get kinked when the
bar is pulled up.
between the upper and lower push bars and
the engine in order to prevent any chafing.
slip and cause damage or injuries during
transportation.