Ki Mobility Rogue XP Manual De Instrucciones Y Garantía página 53

V. SET UP & USE OF YOUR WHEELCHAIR
EE. Rogue XP Dynamic 5th Wheel (Optional)
1. Adjusting spring force
a. Remove dynamic 5th wheel assembly from chair. See Rogue XP Dynamic 5th Wheel
(Optional) on page 50.
b. Loosen 6mm screw located on the underside of assembly (Fig. 47:A).
c. To decrease spring rate, slide screw and elastomer away from caster fork assembly. To
increase spring rate, slide screw and elastomer towards caster fork assembly.
d. Retighten 6mm screw (Fig. 47:A). Take care to not overtighten.
2. Changing or replacing elastomer
a. Remove dynamic 5th wheel assembly from chair. See Rogue XP Dynamic 5th Wheel
(Optional) on page 50.
b. Remove 6mm screw from side of dynamic 5th wheel arm (Fig. 48:A). (Two 4mm Allen
wrenches are needed for this step)
c. Using Allen wrench, push threaded barrel (Fig. 48:B) out of arm assembly.
d. Slide tubular receiver (Fig. 48:C) out of assembly.
e. Remove 6mm screw located on the underside of assembly. This will release the elastomer
(Fig. 48:D). Remove elastomer and set aside.
f. Insert elastomer into opening on arm assembly with threaded insert facing down backwards
slot, aligned with slot in arm.
g. Thread 6mm screw and washer (Fig. 48:D) through slot and into threaded insert in elasto-
mer.
h. Retighten 6mm screw (Fig. 48:D). Take care to not overtighten.
i. Reinsert tubular receiver (Fig. 48:C) into arm. Take care to place flat arm of tubular receiver
over the top of elastomer.
j. Align holes on arm and tubular receiver to insert threaded barrel (Fig. 48:B) and 6mm (Fig.
48:A).
k. Tighten 6mm screws (Fig. 48:A). (Two 4mm Allen wrenches are needed for this step)
Fig. 47
A
51
A
B
A
C
D
Fig. 48