Ki Mobility Rogue XP Manual De Instrucciones Y Garantía página 31

V. SET UP & USE OF YOUR WHEELCHAIR
K. Replacing the Camber Tube
5. To install the camber tube on your Rogue XP wheelchair:
a. Center camber tube in camber clamps.
b. Insert camber adapter into end of camber tube. If using 2°, 4°, or 6° camber adapters,
rotate thin wall of threaded end until it is pointing up and through holes align with through
holes in camber tube.
c. Press threaded barrel (Fig. 19:E) into through holes in camber tube.
d. Using two 4mm hex wrenches, insert 6mm screws (Fig. 19:D) into threaded barrel and
tighten securely.
e. Repeat steps 3 – 5 on opposite side of chair.
f. Reinstall rear wheels. See Setting Toe to Zero on page 25 to ensure wheels are properly set
up and to finish installation of camber tube.
C
E
D
A
B
29
Fig. 19