Caster Angle Adjustment - Ki Mobility Rogue XP Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR
N. Caster Angle Adjustment
To maintain optimal performance of your Rogue XP, the front caster housing should always be
aligned perpendicular to the ground. Your Rogue XP is shipped aligned. Many of the adjustments
made in properly setting up the wheelchair, however, will result in the caster housing getting out of
alignment.
After all other adjustments are made, you should check your caster housing alignment and realign
if the housing is not perpendicular to the ground.
Adjusting the Caster Angle:
For optimum performance, the caster housing should always be at a 90° angle to the floor
(perpendicular to the ground).
1. To change the angle you will need an M5 Allen wrench.
2. Loosen the M8 button head cap screw (A) on the bottom of the caster housing win
(Fig. 22). Then turn the screw on the top of the caster housing wing (B). Loosening will
begin to tilt the caster forward. By tightening you will turn rearward.
3. Turn until you have aligned the caster stem so it is perpendicular to the floor.
4. Place a large right triangle against the flat surface of the fork as shown (Fig. 23).
5. With the rack and pinion system of the Rogue XP, the casters should always be able to be
square.
A
Fig. 22
B
32
Fig. 23