Tabla de contenido
Idiomas disponibles
Idiomas disponibles
V. SET UP & USE OF YOUR WHEELCHAIR
S. Backrest Angle Adjustment
1. To adjust the backrest angle:
a. Loosen 6mm screw (Fig. 31:A) on outside of backrest plate. Do this to each side of back-
rest.
b. Remove 5mm screw (Fig. 31:B) on outside of backrest plate. Do this to each side of back-
rest.
c. Once desired backrest angle is achieved, realign holes in pivot bracket (Fig. 31:C).
d. Reinsert 5mm screw through locating holes and tighten. Repeat on other side of backrest.
e. Retighten 6mm screw (Fig. 31:A). Repeat on other side of backrest.
Fig. 31
WARNING: Adjusting the relaxed position or changing the back angle may decrease rearward
stability. Always make adjustments in small increments and check the stability of your chair with a
spotter to prevent a tip-over. Failure to heed these instructions may result in a fall, tip-over or loss
of control causing severe injury to the user or others.
C
38
A
B
Capítulos
Tabla de contenido
