Installation Of The Rear Fixing Bracket - V2 ZORUS Manual Del Instalador

3.2 - INSTALLATION OF THE REAR FIXING
BRACKET
Calculate the rear bracket position using chart.
450
400
350
90°-95°
300
250
200
150
95°-100°
100
100 150
A (mm)
This chart is used to define distances A and C and the leaf
maximum opening angle.
max
A
398
C
MO LINK 180
MO LINK 420
100°-110°
110°-120°
200 250 300
Installation
examples
MO LINK 180
MO LINK 420
1
1
1
1. Measure value "C", then trace a straight horizontal
line in chart 1 against the obtained valued. Select
a point in the line, taking into account the desired
opening angle, suitable for the column.
2. Trace a vertical line starting from the point identified
and obtain value A.
3. Before proceeding with the installation, make sure
that value A allows to fix the rear bracket, otherwise
select another point on the chart.
4. Finally, to fix the bracket on the leaf, refer to the
maximum dimensions of the arm.
Failure to comply with the bracket installation
distances may lead to automation operation faults,
such as:
- Cyclical movements and accelerations at some
positions of the stroke
- Increased motor noise
- Limited opening, or no opening at all (in case of
counter-lever fixed motor)
m
WARNING! Before fixing the rear bracket, make
350
sure that the front bracket will be fixed to a solid
position of the gate leaf; the front bracket will have
to be secured at a different height than the rear
bracket.
A C
140 30 90
250 30 120
140 80 90
190 80 100
140 130 90
170 130 100
140 160 90
160 160 95
5. At this point, mark on the leaf and on the wall the
140 200 90
holes of the brackets which will then be used to fix
160 200 95
the two brackets
6.
Fix the rear bracket of the motor to the wall
A C
complying with the dimensions seen previously
140 30 90
250 30 110
140 80 90
185 80 100
140 130 90
170 130 95
140 160 90
160 160 95
140 200 90
150 200 90
140 240 90
150 240 90
140 280 90
170 280 90
140 320 90
170 320 90
- 40 -