Deleting A Step From A Chase; Deleting A Chase; Deleting All Chases - Chauvet DJ Obey 40 D-Fi 2.4 Manual De Usuario

Deleting A Step
From A Chase

Deleting A Chase

Deleting All
Chases
Obey 40 D-Fi 2.4 User Manual Rev. 3
Deleting a step from a chase is removing a step from a chase, but it does not remove the scene
saved into the step..
Deleting a step from a chase does not delete the scene in the step. The scene remains and
can be saved into other chases, or played back on its own. See
information on how to delete a scene.
The general instructions for deleting a step are as follows:
1. Enter Program mode.
2. Use the chase buttons to select the chase from which the step will be deleted.
3. Use the bank buttons to select the step to delete. The LED display shows the current step just
above the word Bank.
4. Press <Auto/Del> to delete the step.
5. Repeat steps 3–4 or steps for other steps, or repeat steps 2–4 as needed for other chases.
6. Exit Program mode.
7. Reset faders to 0 and deactivate blackout.
The specific instructions below describe how to delete step 5 from <Chase 5>.
1. Enter Program mode.
2. Press <Chase 5>.
3. Press <Tap Sync/Display>.
4. Press <Bank Up> or <Bank Down> until 5 shows in the LED display just above the word Bank.
5. Press <Auto/Del>. The LED display and fixture button LEDs flash to indicate a successful
operation.
6. Repeat steps 3–5 or steps for other steps, or repeat steps 2–5 as needed for other chases.
7. Exit Program mode.
8. Reset all the channel faders to 0.
9. Press <Blackout> to deactivate blackout and allow DMX transmission from the board.
Deleting a chase is removing the entire chase, but not the scenes saved into the chase. The general
instruction for deleting a chase are as follows:
1. Enter Program mode.
2. Use the chase buttons to select the chase that will be deleted.
3. Press <Auto/Del> and the chase button simultaneously.
4. Repeat steps 2-3 as needed for other chases.
5. Exit Program mode.
6. Reset faders to 0 and deactivate blackout.
The specific instructions below describe how to delete <Chase 3>.
1. Enter Program mode.
2. Press <CHASE 3>.
3. Press <Auto/Del> and <CHASE 3> together. The LED display and fixture button LEDs flash to
indicate a successful operation.
4. Repeat steps 2–3 as needed for other chases.
5. Exit Program mode.
Deleting all chases removes all the programmed chases from the board, but it does not remove the
scenes or any customizations. To delete all chases do the following:
1. Enter Program mode.
2. Press <Auto/Del> and <Bank Down> together.
3. Turn the board off while still holding <Auto/Del> and <Bank Down> together.
4. Turn the board on.
Deleting A Scene for
Page 33 of 176