Idiomas disponibles
Idiomas disponibles
Accessories
Check to make sure you have the following accessories before disposing of the packing material.
³
Remote Control
For U.S. models:
For optional accessories, please access our web site at:
www.hitachi.us/tv
CAUTION:
1. Ceiling mounting is not recommended. Mounting the panel on the ceiling does not
2. This stand for use only with Hitachi P42T501 and P50T501. Use with other
3. The wall mount unit for the 50" and 42" models is WM07S and for the
³ Remote Control Unit CLU-4371A
(Part No. HL02401).
· Two "AA" size, 1.5V batteries.
» Table Top Stand (UX27662 42" model)
(UX27282 50" model).
¿ Power Cord (P# EV01841).
REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT
1.
Open the battery cover of the remote control by pushing down and sliding the back cover off.
2.
Insert two new "AA" size batteries for the remote control. When replacing old batteries, push them towards the
springs and lift them out.
3.
Match the batteries to the (+) and (-) marks in the battery
compartment.
4.
Insert the bottom of the battery, the (-) side, into the battery
compartment first, push towards the springs and insert the
top of the battery, the (+) side, into place. Do not force the
battery into the battery compartment.
5.
Replace the cover.
CAUTION: Do not insert batteries with '+' and '-' polarities reversed as this may cause the batteries
to swell or rupture resulting in leakage.
4
·
Two "AA" size,
1.5V batteries
»
Table Top Stand
(50" included)
provide adequate ventilation for the electronics or proper support for the front glass
panel. This plasma television product is designed for a maximum tilting angle of 45
degrees from vertical.
apparatus is capable of resulting in instability causing possible injury.
55" models is WM07L. Please see page 7 & 8 for important information related
to the wall mount. Wall Mout unit is an optional accessory (Not Included).
¿
Power Cord
»
Table Top Stand
(42" included)
Note: Please visit our
website for optional
accessories.
Bottom View (Remote Control)
Lift up on tab to remove back cover.
