Package Contents - Heath Zenith 7560 Manual Del Usario

This chime unit is designed to work with:
• Wired push buttons (see Wired Chime Installation, page 3)
• Wireless push buttons (see Wireless Chime Installation, page 6)
• Combination of both wired and wireless push buttons (see Wired
Chime Installation, page 3)

Package Contents

• Multi-Tune Wireless and Wired Combination Base
• Chime Cover
• Mounting Hardware
Items needed for installation (not included):
• Phillips and flathead screwdrivers
• Safety glasses • Drill
For Wired Installations
• 16 Volt AC, 10 Watt or a 16 Volt
AC, 15 Watt Transformer
• Wired Push Button(s)*
• Wire strippers/cutters
• Pliers
• Masking Tape
• Marker
*A wireless Heath ® Zenith push button may be added to a wired
system.
• 7/32" (5.5 mm) Drill Bit
For Wireless Installations
• 3 "C" Alkaline Batteries (when
used as a wireless chime only)
• Wireless Heath Zenith Push
®
Button(s)
-2-
REMOVING CHIME COVER
Firmly pull on cover to remove it from chime base. Note: Never use
cleaners or polishes. Never use any fluids on the electronic chime
mechanism. Use dry cloth to clean chime cover and base.
Illustrations may vary from actual chime unit.
Questions or problems?
Before returning to your retailer, refer to the troubleshooting guide
in this manual or visit our web site at www.hzsupport.com. If the
problem persists, call our technical service department at 1-800-
858-8501 (English speaking only), 8:00 am to 5:00 pm, CST,
Monday – Friday.
207702-02
SYNC – PRESS
AND RELEASE.
RESET – HOLD
10 SECONDS.
TUNE – HOLD
FRONT TRANS REAR
1 SECOND.