Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5.
Installation: Hardware
Refer to the illustrations on page 2 of this manual.
1.
Choose a location for the camera, keeping following guidelines in mind:
do not install the camera in locations where extremely high or low temperatures or
o
excessive vibrations may occur.
avoid mounting the camera near high electro-magnetic fields.
o
do not aim the camera at the sun or other extremely bright objects or reflections (e.g.
o
metal doors).
2.
Loosen the socket head screw [e] using the appropriate hex key (not incl.).
3.
Hold the mounting plate [a] and unscrew the fixation ring [b] by turning it counter-
clockwise. Note that the lens enclosure [d] and positioning ring [c] are also released.
4.
Use the mounting plate [a] to determine the position of the mounting holes. Drill the holes.
5.
Guide the cables [g] through one of the cable slots [f] and fix the mounting plate [a] on
the ceiling or wall with four screws.
6.
Insert the lens enclosure [d] in the positioning ring [c] and slide the fixation ring [b] over
both. Point the camera towards the desired field of observation and screw the fixation
ring [b] back on the mounting plate [a].
7.
Fasten the socket head screw [e] using the appropriate hex key (not incl.).
8.
Connect the camera. Refer to chapter 6. Installation: Power Supply and PoE.
6.
Installation: Power Supply and PoE
Power Supply
For your camera to work properly, you need to connect the camera cables as follows:
1.
Connect the network cable [1] to your network.
2.
Plug the camera's power cable [4] in a suitable power adapter (12 VDC 1 A, for example
PSSE1210, not incl.) and connect it to a power socket.
PoE (Power over Ethernet) Connection
The camera features PoE (Power over Ethernet). If your router or hub supports PoE, you do not need to
connect the camera to a power socket. You can then connect the camera as shown below:
1.
Use a network cable [6] to connect your camera [7] to a PoE port of your router [5].
2.
Make sure your router is connected to a power socket [8].
Note: If your router does not support PoE, you can use a PoE injector (not included) to use the PoE
feature.
V. 01 – 15/07/2014
CAMIP20
1
8P8C network cable
2
RESET
3
GND
4
power cable
5
PoE router/hub
6
LAN cable
7
camera
8
power
4
©Velleman nv
Tabla de contenido
