Husqvarna PG 540 Manual Del Usuario página 13

4. Loosen the lock knobs (D).
D
E
5. Adjust the handlebar (E) to the correct position.
6. Tighten the lock knobs to set the handlebar position
(F). When the handlebar position is set, pull the
handle lock knobs out and put them into idle
position.
To connect the product to a power
source
1. Connect the power plug of the product to the
extension cable.
2. Connect the extension cable to a mains outlet.
1211 - 003 - 22.01.2020
3. Hang the power cord on the suspension device at
the door to electrical box to prevent tension in the
power cord.
F
Operation speed
If the product is operated on a new surface type, set the
speed to 70% initially. When the operator knows the
surface type, the speed can be adjusted.
Direction of rotation of the grinding
discs
Seen from below the product, the direction of rotation is
as follows:
• "CW": clockwise
• "CCW": counterclockwise
During operation the product can pull to the side. The
direction of the pull is related to the direction of rotation.
The product pulls to the right when the direction of
rotation is set to "CCW". The product pulls to the left
when the direction of rotation is set to "CW".
The side pull can help you operate the product for
example near a wall. Set the direction of rotation to pull
in the direction of the wall.
CAUTION: When the product is connected
to a dust extractor, the dust extractor must
be connected to a 3-phase power source.
CAUTION: Steer the product carefully. Make
sure that the product only lightly touches the
wall. The product is heavy and can cause
damage.
13