THERMEx CENTRALVENTILATION VILLA II Instrucciones De Montaje página 72

72 THERMEX CENTRALVENTILATION VILLA II
The remote control for the Centralventilation Villa II has a range of 500 m (max. in free terrain - line of sight), and the unit uses two CR2032
batteries. As the remote control is radio controlled and battery-powered, it can be placed in any location.
Before the remote control is taken into use,
the buttons must be removed. When the buttons on the remote control are activated, a small red diode at the top of the remote control lights
up in the middle of the words 'Villa ventilation' . This indicates that the remote control is sending a signal.
NOTE: Always check that the remote control is in range of the selected location before the remote control is installed.
The remote control is installed with two pieces of tape located on the back of the remote control. Remove the protective foil from the tape and
place the remote control in the desired location (however not in a wet zone).
NOTE: Always clean the surface thoroughly with alcohol before the remote control is installed with tape.
The remote control may also be installed with screws: This is done as follows:
1
Remove the back plate from the remote con-
trol by inserting a sharp object into the two
clips at the bottom of the remote control.
4
Pre-drill the holes and install rawl plugs suit-
able for the material onto which the remote
control is to be installed.
the plastic protection that is located over the batteries in the remote control
2
Drill the holes on the back plate.
5
x2
Screw the back plate on to the wall and click
the remote control on to the back plate.
3
Mark the holes on the wall where the remote
control is to be located.
6
The remote control is now ready to use.
x2
M 536991040901102019
and the protective film over