Cleaning Instructions - Weston BUTCHER Serie Manual De Instrucciones

CLEANING INSTRUCTIONS

WARNING!
Grinder, make sure the Grinder Motor is OFF and the PLUG IS REMOVED
FROM THE OUTLET/POWER SOURCE!
1. Remove the Head Assembly from the Grinder Motor.
2. Disassemble the Head Assembly.
3. Wash all parts that have come in contact with meat in hot soapy water. BE
SURE TO CLEAN IMMEDIATELY AFTER USE. DO NOT IMMERSE THE
MOTOR IN WATER OR OTHER LIQUIDS!
4. Rinse the Grinder parts with clean hot water, then dry them IMMEDIATELY.
5. Fully lubricate the Head, Plates and the Knife with a food grade silicone
spray before and after each use.
6. Clean the Motor Cover and Gear Housing with a damp towel and wipe dry. DO
NOT IMMERSE THE MOTOR IN WATER OR OTHER LIQUIDS!
IMPORTANT: Any metal parts should be coated with a food safe silicone spray
to prevent rusting. If not properly protected, these parts can begin to rust very
quickly. DO NOT use rusted parts. Ordering information can be found on the
last page of this instruction manual.
7. Make sure the grinder and all components are completely dry before assembling
or storing.
8
Before cleaning, assembling or disassembling the
WARNING!
NEVER operate Grinder without the
Tray secured in place.
To avoid serious or fatal injury, NEVER reach
into any Grinder inlet.
ALWAYS use the Stomper to push meat
into the Grinder Head.
Read & fully understand all instructions
& warnings prior to use.